DP-9CT2 Two-Component Pump with Flush Pump

System features and coating setup

This two component polyurethane injection pump is suitable for every kinds of low to high viscosity liquid materiasl.

The wet components use stainless steel material, which could be used for spraying both water-based or oil-based material.
Less splash of paint, paint saving and Eco-friendly
External mixing reduces equipment failure rate resulting from material solidify
Provides accurately mixed and proportioned material to reduce waste.

It is used in the construction and mining industry for the injection of polyurethane and is especially suited for high volume water control, void filling and deep injection applications

Can I use the DP-9CT2 for two-component polyurethane injection or dispensing?

The listing describes pneumatic component pumps and a separate flush pump, with construction and mining injection applications. Confirm the exact resin system, ratio, mixing or injection head, working time and delivery requirement. Do not treat every spray, injection and dispensing arrangement as interchangeable.

What should I confirm for water-control or void-filling resin?

Provide both component data sheets, required mixing ratio, reaction characteristics, injection method and the site specification. Confirm material and cleaning-fluid compatibility with the supplied pumps, hoses and head. The equipment’s pressure capability does not establish an appropriate injection pressure for a particular structure.

Does the pressure ratio describe the resin-to-hardener mixing ratio?

No. Pump pressure ratio and component mix ratio describe different requirements. Confirm the actual proportioning arrangement and ratio-check method for the named material before use. Do not read the listed air-to-fluid pressure ratio as an A:B material ratio.

What is the separate flush pump used for?

Its intended use and connections must follow the supplied system instructions and the material’s approved cleanup procedure. Confirm which passages require flushing and the correct compatible fluid before operation. Do not send solvent or a reactive component through a circuit merely because a connection fits.

What should I do if the mixed material cures unevenly or output becomes intermittent?

Stop the application and follow shutdown and pressure-relief instructions. Check separate component supply, approved ratio verification, restrictions and mixing-head condition. Follow the material supplier’s process for suspect off-ratio material; continuing to raise pressure cannot correct an incorrect mix.

Where can I buy a DP-9CT2 or discuss a distributor order?

We do not currently sell single units directly to end users. Leave your phone number through our contact form, and we will pass it to a local dealer. Dealers hold stock and can usually deliver within one week; confirm availability for this model and configuration. For distribution or OEM enquiries, tell us your market and planned order mix.